Page 1 of 1

Vems pnp for 3b question

PostPosted: Fri May 25, 2018 6:33 pm
by quattrobros
Ive been running the vems pnp setup for about a year now and im curious as to what is all not being used.

There are two knock sensors on by block and i dont think vems uses knock detection at least not im my case. Can anyone confirm this? Can i remove them?

also i see some poeple dont have an isv? How do i go about doing that?

Just trying to clean up my harness as the motor is not in the original car.

Re: Vems pnp for 3b question

PostPosted: Sat May 26, 2018 5:59 pm
by varia
vems can use knock sensors

Re: Vems pnp for 3b question

PostPosted: Fri Jun 01, 2018 6:38 pm
by Juizer
How to wire stock knocks to vems?
Guide for dummies please.

OT/ Maxxecu points to use Bosch 0261231046 sensors which only have 2 pin connectors vs stock 3 pin ones, and are not polarity sensitive.
Maybe vems needs these as well instead the stock ones? /OT