Vems pnp for 3b question

Discuss VEMS and other standalone ECUs

Vems pnp for 3b question

Postby quattrobros » Fri May 25, 2018 6:33 pm

Ive been running the vems pnp setup for about a year now and im curious as to what is all not being used.

There are two knock sensors on by block and i dont think vems uses knock detection at least not im my case. Can anyone confirm this? Can i remove them?

also i see some poeple dont have an isv? How do i go about doing that?

Just trying to clean up my harness as the motor is not in the original car.
Posts: 31
Joined: Jul 20, 2015

Re: Vems pnp for 3b question

Postby varia » Sat May 26, 2018 5:59 pm

vems can use knock sensors

project 2226
Posts: 291
Joined: Mar 18, 2013
Location: Los Angeles

Re: Vems pnp for 3b question

Postby Juizer » Fri Jun 01, 2018 6:38 pm

How to wire stock knocks to vems?
Guide for dummies please.

OT/ Maxxecu points to use Bosch 0261231046 sensors which only have 2 pin connectors vs stock 3 pin ones, and are not polarity sensitive.
Maybe vems needs these as well instead the stock ones? /OT
Posts: 71
Joined: Jan 24, 2015
Location: Finland

Return to Standalone Engine Management

Who is online

Users browsing this forum: No registered users and 2 guests