Vems pnp for 3b question

Discuss VEMS and other standalone ECUs

Vems pnp for 3b question

Postby quattrobros » Fri May 25, 2018 6:33 pm

Ive been running the vems pnp setup for about a year now and im curious as to what is all not being used.

There are two knock sensors on by block and i dont think vems uses knock detection at least not im my case. Can anyone confirm this? Can i remove them?

also i see some poeple dont have an isv? How do i go about doing that?

Just trying to clean up my harness as the motor is not in the original car.
quattrobros
 
Posts: 32
Joined: Jul 20, 2015

Re: Vems pnp for 3b question

Postby varia » Sat May 26, 2018 5:59 pm

vems can use knock sensors
¯\_(ツ)_/¯

project 2226
varia
 
Posts: 310
Joined: Mar 18, 2013
Location: Los Angeles

Re: Vems pnp for 3b question

Postby Juizer » Fri Jun 01, 2018 6:38 pm

How to wire stock knocks to vems?
Guide for dummies please.

OT/ Maxxecu points to use Bosch 0261231046 sensors which only have 2 pin connectors vs stock 3 pin ones, and are not polarity sensitive.
Maybe vems needs these as well instead the stock ones? /OT
Juizer
 
Posts: 72
Joined: Jan 24, 2015
Location: Finland

Re: Vems pnp for 3b question

Postby 88a5tq » Sat Jun 23, 2018 11:29 am

Not sure about what you posted from Maxecu but MANY people are using stock knock sensors fine on 3B and AAN or with stock bolt-through version from either on the older 10vt's as an update. Wait until you see the FAQ concerning dialing in the knock settings lol! Don't be discouraged and decide if you want to run one or 2 sensors from the start.
Janitor at large
1991 Audi 200 TQ HX35 (finally 56mm)
$500 butt-hurter
1988 Audi 5000 TQ
User avatar
88a5tq
 
Posts: 1549
Joined: Jul 16, 2014


Return to Standalone Engine Management

Who is online

Users browsing this forum: Google [Bot] and 3 guests

cron