the diagram for the n75 valve had just said "pressure input" so I wasn't real sure.
So best bet would be brake booster to the large portion on the intake with a check valve.
and the rest to the remaining 3 ports on the intake.
Thanks for the input here.

I'm finally getting around to working on my car again and I'm trying to set up the vacuum. The car is a CQ that basically has a 3b in it running off of VEMS.
I have a short runner from Iroz, which has 1 3/8 port, 3 1/8th ports.
Aftermarket N75 valve.
Stock wastegate and stock brake booster.
Tial BOV ...

I just finished rewiring the interior wiring to the fusebox in my 90 CQ. The fusebox wiring is fairly straightforward, and I only have two connectors that I hope solve my issues.


This is a diagram of the rear of the fuse box.


Here are the two wires

Hey everyone. I'm getting ready to finish the engine bay wiring this week. I have a few questions about the wiring so I dont make a mistake. I am running vems on 20v hybrid with a 3b intake/throttle body.

First I have the 034 TTL single coil pack.
https://store.034motorsport.com/media ...

Forgot to add in my original post that I'm keeping the distributor for now.

Is there an ideal coil pack to use? the engine is a ghetto 20vt. I have an 034 TTL coil that has been sitting around for a while. Is there a better alternative?

so I've been slowly trying to chip away at this project weather/work permitting.

I have a few questions I hope someone can help on out

1. what is the fuel line inlet size on the AAN fuel rail.
2. what is the fuel line size for the CQ 7A
3. Is there an aftermarket option for a coilpack to run the ...

Finally had enough time to get the 7A yanked out.
IMG_20150415_095838.jpg


Took a lot longer than I thought it would, I'm just used to working on vr6's and theres not 12 bolts holding the trans to the engine.
IMG_20150415_095742 (1).jpg

This weekend I'm going to work on getting the subframe ...

It was a very nice day outside,so I spent some time getting the engine ready to pull out.
https://lh3.googleusercontent.com/-WXdR8cloHUI/VSBLHYuMEaI/AAAAAAAACtI/JM64u2C7Uvw/w987-h740-no/IMG_20150404_160306.jpg
https://lh3.googleusercontent.com/-SQZaiDdDFEk/VSBLEx0JWCI ...

not yet, I have to work on it outside, and since this is Ohio the weather goes from 60 to 20 with an inch of snow every other day.

I also wanted to make sure I did all my research before I started it since I'm new to stand alone.
the only thing I need to double check is that I can still use the ...

small update.
this week I'm going to put in my order to Marc and start getting parts coming my way. I decided to hold off on upgrading the turbo since I'm on a slight budget and this car definitely needs new tie rods/ball joints.

I plan on just keeping the k26 and aan injectors for now and ...

I planned on getting an 01e after the engine swap which shouldnt be too difficult of a task. The stock 7A has almost 220k miles and makes no power after 3k rpm, so I kind of want a more reliable engine. It's not like I plan on taking it to the drag strip or track...yet.

I'm new to the project pad, but I have been lurking here and motorgeek for a while trying to gather information.
I've owned the car for a few years now, and purchased the engine last year. I finally am now able to work on the swap.
976409_10151982624899408_762653968_o.jpg
20140202_165837.jpg
I ...