Andy's 91' 80q

[rennenmsports]

3880B17E-C611-4865-8002-9658234DAFDF.jpeg (65.38 KiB) Viewed 5560 times

Urs front hub with an E36 wheel bearing. Had to take about 3mm off the knuckle in a cone shaped angle. it’s definitely a really tight fit

[rennenmsports]

A6612661-0261-4428-B434-5D0ED4EB53C0.jpeg (106.21 KiB) Viewed 5541 times

Bruce lee’s 1 inch punch to spread the transmission tunnel for the 01E 6 spd

[rennenmsports]

B0D75535-5CB9-4EBA-9DF5-628798B9B987.jpeg (131.06 KiB) Viewed 5538 times

It’s getting really close. Just need a front brake set up. If anyone has one for sale please pm me

[rennenmsports]

CF9C3DED-512F-4777-A2C2-B562E0C85109.jpeg (69.07 KiB) Viewed 5392 times

I used a counter sink bit to be able to use a flat headed taper bolt so I can install a -10an banjo fitting for the transmission cooler

[rennenmsports]

18FB8EC4-FCC2-4933-9C03-8579D24904E2.jpeg (159.74 KiB) Viewed 2529 times

Rebuilt prop shaft center support
Bearing from McMaster carr 4668k295 works

[rennenmsports]

-10 lines for the transmission cooler

70682280128__A94618B9-0B8E-41DB-B75A-29EE7C948027.jpeg (104.79 KiB) Viewed 168 times

70682279011__70E6D2CA-F54F-420E-B965-1336A19FA256.jpeg (106.8 KiB) Viewed 168 times

[DE80q]

Does it move on its own power yet?

[rennenmsports]

Does it move on its own power yet?

Almost waiting on a T fitting to finish the engine oil cooler lines. I was bleeding the brakes when the master decided to go out. Glad it did at home. It is original. Also rear sway bar end links and a DIY alignment so I can get it to an alignment rack. But that doesn’t keep it from moving on its own. The last thing is to tune the VEMS. I’m all the way down in south Florida so I’m hoping Marc can help remote tune it at some point. No idea what that entails.

[rennenmsports]

I figured out a simple way to strengthen the push rod on the clutch master. I just stacked up nuts and grinded one down to meet the necessary adjustment

70507743513__763B045D-23F9-4275-89B9-EE3973082101.jpeg (116.93 KiB) Viewed 114 times