The Project Pad

Little late posting these but I did pick up my Miller 210 Tig finally a couple weeks ago. After practicing, these are the results so far. I'm updating the motor mount plate thread and taking orders.

These first two pics were going vertically up

oohhh, diamond plate dress up parts for your 20v swap into the Dodge?

lol, big improvement!

Yeah yeah.....just wait till that dodge is back on the road. You wont be laughing then lol!!

Looks like it's getting there, nice work. What thickness aluminum are your mounts going to be? Welding thicker aluminum requires a ton of heat!

They will be same size as the steel ones (1/4"). Since the welding is for a non load bearing piece, I wont need full penetration. Either way, I am striving for a perfecr weld and will be pre-heating with the oxy-ace torch

I love TIG welding! It relaxes me! People do Sudoku, Crosswords, knit...etc. I weld! LOL

I have a long way to go on this but have spent quite a bit of time practicing. Do you run the welder in pulse mode?
I need to get the timing better of moving the puddle forward and dipping the rod.

Ive played with the pulse but these pictures are straight pedal. Pulse mode requires a good rythem which I havent got down yet.

AngryTaco wrote:requires a good rythem which I havent got down yet.

white boy.

Lol