The Project Pad

So I have a 84 Audi 4000Quattro that has been gutted and roll caged, has a 2.1 block bored out to replace my mc2 block, ported and polished head, intake, and exhaust manifold, exhaust manifold and k24 have been ceramic coated, 3" pipe out, 32lb injectors, air to water intercooler, ran by ms1-extra fired by 5 window hall sensor. I am having issues finding a timing and fuel map if there is anyone that could help a a b2 fanatic it would be awesome

Shoot deaner a PM. His setup is for an MC1, but should e a good starting point.

Cool thanks

I have an msq that vt10vt sent over to me a couple of weeks ago. I've never driven on it, just got it idling decently. Is your car running at all audidoug? I'm not exactly sure what etiquette is with sharing maps and all, being as it isn't mine. I was in the same boat as you a couple weeks ago and vt10vt shared an old one with me. If it was mine I'd gladly send you the msq, maybe Shawn will pipe up or someone can fill me in on protocol when using and/or sharing someone else's map?

Yeah go for it, I'm happy to share any of my work.

Thanks anything helps im pulling my hair out trying to get this hall sender trigger angle timing issue every time I get the fixed angle back down to -10 it dies then it's a beast to get started again

vt10vt wrote:Yeah go for it, I'm happy to share any of my work.

Cool man, just wanted to make sure.

Audidoug, PM me your email address.