The Project Pad

So very recently shortly after getting the car up and running I found that the ego correction wasn't showing as being lit as often as he used to be iirc. It's like the settings are correct but it doesn't appear to be shown as on as frequently in Idle as it used to be and it shows in the lack of Correction being done. Anyone else seen this with the new firmware and nightly build vemstune or the nightly build being used with a late 2014 fw?

The less that light is on, the better your tune is lol

Can't argue with that hah

Maybe the tune is just better with your fresh engine

Ya that would be a nice ending to the story

I was just concerned when I looked down and noticed the lambda was rich at idle and looked up higher to see the ego bar said off. I have since gotten the table even better. It's amazing how much easier things are when using an engine that keeps all its fluids in their perspective places lol

*Respective.

Sorry...

Yep you're right

Btw I've figured this out. My reactivation cycles was 218 and I dropped it to 50 and it's back on now when I prefer

Glad you figured it out.

88a5tq wrote:Btw I've figured this out. My reactivation cycles was 218 and I dropped it to 50 and it's back on now when I prefer

My reactivation delay is only 6 cycles. Is that too fast?

Lol dang I wouldn't think so. I dropped mine again today to 20 but I was on the fence about lower

I think mine is at 4. Less than 10 would be good

Thanks Colin, I did change to 6 not long go. I may go to 4 though.