Page 1 of 1
Energy Suspension urs4 engine mount install.
Posted: Sun Apr 06, 2014 7:27 pm
by pilihp2
Attempting to put some energy suspension mustang tranny mounts into a urs4. I saw a picture somebody did in paint just the other day but now I can't find it. Can anybody explain exactly what needs to be cut on these things?
Re: Energy Suspension urs4 engine mount install.
Posted: Sun Apr 06, 2014 9:55 pm
by PRY4SNO
Notch the bracket on one side, and the insert on the other, IIRC.
Saw it the other day too and can't remember where either haha
Re: Energy Suspension urs4 engine mount install.
Posted: Mon Apr 07, 2014 1:27 pm
by yodasfro
Re: Energy Suspension urs4 engine mount install.
Posted: Mon Apr 07, 2014 2:02 pm
by EDIGREG
FYI, rather than cutting the factory cast pieces like shown in OB's photos below, I modified the energy mount as necessary to make everything fit
Re: Energy Suspension urs4 engine mount install.
Posted: Wed Apr 09, 2014 10:00 am
by pilihp2
Oh wow, okay. Didn't know you needed to trim the urethane and the engine mount bracket. Got the driver side on with just a slight trimming of the mount. Now for the passenger. Thanks guys.
Re: Energy Suspension urs4 engine mount install.
Posted: Wed Apr 09, 2014 10:40 am
by PRY4SNO
PICS!
Re: Energy Suspension urs4 engine mount install.
Posted: Fri Apr 11, 2014 12:08 am
by PRY4SNO
Found what I was referring to, courtesy of WAUG0806's FS thread on MG
Re: Energy Suspension urs4 engine mount install.
Posted: Fri Apr 11, 2014 10:16 am
by pilihp2
Yea I just saw that in his thread too. Turns out, I cut one the wrong direction. Time to weld the mistake, haha. Good thing I bought an extra set for my car.