Ed's 1991 CQ: Progress!

[loxxrider]

YAY!

No boost piping yet right? Feels good to get it out and drive doesn't it?

[Mcstiff]

It should be running on the spring (signal line to lower port); it did not feel like I was getting much. One of the pipes could have slid off since I still need to bead roll them.

Feels great to get it out!

[40v4kq]

Man that first drive feels good(well, first drive in a while anyway).

[Audilard]

:woowoo: Very nice Ed! I'm anxious for that day for my car!

[jbrentd]

Nice Ed!

[audifreakjim]

:woowoo:

[90quattrocoupe]

:stupid:

[PRA4WX]

Awesome!
Did you get a chance to see how close the exhaust is?

[quattro87]

:woowoo: I like it.

[Mcstiff]

Awesome!
Did you get a chance to see how close the exhaust is?

Very close! I'll take it to get welded tomorrow but they should not have much trouble getting it to fit.

Attachment:[/quote]

ImageUploadedByTapatalk1341778211.382750.jpg [ 195.85 KiB | Viewed 611 times ]
[/quote]

[Mcstiff]

Other notables, I re-pinned my harness so that the injectors and coils go 0-4 so that things make sense without my xls in front of my face. Going to try and tune some more this afternoon and tomorrow.

[Mcstiff]

Link to video

[Audilard]

Nice job Ed! Come help me put mine back together now.

[my2000apb]

yay

[loxxrider]

You are going too slowly in these videos. I was hitting 25 psi on my motor after putting it back in and driving for the first time with the new turbo, hg, im, em, etc.!

[Mcstiff]

You are going too slowly in these videos. I was hitting 25 psi on my motor after putting it back in and driving for the first time with the new turbo, hg, im, em, etc.!

I think you had a better baseline Hope to tune tomorrow, it's been a busy week and I've changed a few things in the base setup to make things more correct (forgot to adjust for 4bar FPR) Still need to get the vband welded on the mid-pipe

[UrSobsessed]

Yay Ed!

[loxxrider]

You saw my first startup vid. The car would barely even run.

I'm just teasing really, but I wanna see some fast and hear some turbo

[Mcstiff]

:frustrated:I have two voltage regs and they both seem to be dead :frustrated: Makes tuning difficult!

[Mcstiff]

Well, I'm not sure if it is the low battery but I cannot seem to get my idle stabilized. Could be plugs or just the low power... https://docs.google.com/open?id=0B0w5Fw ... GdaNjhTR28

[loxxrider]

Sometimes if the idle hunts, the car is just too lean or too rich.

[Mcstiff]

Thanks for looking. I don't have an ISV either so...

I need to sort charging before I can do much more

[loxxrider]

Do you know you have an accurate wideband signal? I'm just suggesting this because it is the easiest place to look first.

[Mcstiff]

It was a new sensor and I calibrated it.

[Mcstiff]

Anyone have a tip on hooking up an RPM signal to the dash?

I know the stock trace runs through "J 114 - Oit pressure warning control unit" (which has been freaking out lol) but I am tempted to convert to a stand alone gauge with a better range.