Looking for a front bumper cover for my 96 a6. Let me know what you have.

welding is possible, but cast-iron does have a tendency to crack again when welded if not welded properly.

I am going to be doing a coil over conversion and wanted to see what ppl are using for a decent stiff but good ride, spring rate? 97 c4 a6

Regarding the size, I had an issue with this as well, a1 is where I got my sleeves, one set wouldn't fit, so I called them and they sent me another pair and it was perfect, a very slight friction fit, it should be 2.170" which is 55.11mm

Hah, anecdotal, yes just trying to help other ppl not wast 200 on a cover that is not necessary...

No cover is necessary. Little different but I road race a mk1 rabbit and have ever had any cover on the belt anywhere. In 7 years never had a single issue.

Problem ended up being a sticking throttle position idle switch. Thanks for input

Codes it has are, p1504 for air leak, p1506 coolant temp short to ground, p0120 for tips a circuit. In the driveway it starts and idles fine, if you press the gas pedal to the floor it will race to about 2600rpm the cut out and do that again. It's bouncing. Any info?

Hey so pulling codes shortly but figured I ask if anyone has seen this. While driving engine looses all power like I let off the throttle. Then will come back, then when o got closer to home it would rev up and then misfire slightly.. when trying to drive now will rev only to 2000 rpm then cut out ...

Thanks for the help, yea I have to measure my struts, and they are not race struts. I will machine spacers at work.

Possibly, but I have some koni adjustable strut cartridges that are 1 inch shorter body then stock as per measurements from monroe. But I know they are slightly smaller diameter then stock so I want to make sleaves in the strut tube for centering purposes. So need the ID of the strut tubes.

What is the inner diameter of the c4 front strut tubes?

Looking for all the heater box actuator motors for my c4 a6. Let me know what you have.

I have a 97 c4 a6, I'm looking for lowering springs. Show me what you have.

So I need to replace the rear control arm bushings on my 97 a6 Quattro. Had a 200 at one point and did poly bushings for the front 2 bushings in the rear control arm. Any info anyone has on what fits, would be great. Thanks.

will do, I did find broken wires in the o2 sensor wireing on the sensor side. fixed those, and ordered a new one... we shall see waiting for snow and wetness to check.

ok ill try that. I should rephrase this a little it really only happens when wet out.

As the title states I have an issue with my 88 Audi 90 with the ng 20v. When cold or when moist out it has a hesitation at part throttle but clears up completely once at full throttle.. Did the obvious, replaced plugs wires cap and rotor, also coolant temp sensor. Did not replace coil yet but might ...

they look like CIS injector O-rings

Bump

ok thanks, next question is which 4.2 engine codes work?

the fith new one in the pic is no longer included.

Just toying with the idea of this swap. Want to see who has real solid info and things necessary to do this swap? Thanks

I have a set of used bilstein strut inserts for sale.. they were in my b3 90 with one piece rear uprights. All compress and rebound well... I'm looking for 150 shipped... The fronts are bilstine gland nuts, the rears are ones I made since I got the shocks second-hand new, but missing gland but. The ...

17's do look ok in my opinion on the 90s, just need it lowered to get rid of fender gap... These are Ford svt rally wheels, 4x108 et49 with 15mm spacers